Z-Wave.Me Z-Uno ver. 2 - Z-Wave Technology Board (700 Series) for Arduino

Product information Z-Wave.Me Z-Uno 2 - Z-Wave Board for Arduino (Z-Wave 700 series)

The Z-Wave.Me Z-Uno 2 Board - Z-Wave Board for Arduino (Z-Wave 700 series) is the perfect solution for DIY scenarios! Connect LEDs, buttons, switches, motors, or any low voltage sensor including most Arduino compatible sensors.

Create your own Z-Wave device by programming a sketch in simplified C language. Z-Wave.Me Z-Uno 2 is the perfect companion for your RaZberry catwalk. Find more information at https://z-uno.z-wave.me

Features:

Control any Arduino compatible peripheral
Define your own logic by modifying your sketch
Use the IDE and the Arduino language to write and load the sketches
Easy to use
Does not require knowledge of the Z-Wave protocol
Complete DIY solution
Z-Wave 700 Series

Hardware specification:

40 kB of Flash memory for your sketches
8 kB RAM
2 kB EEPROM
Z-Wave RF transmitter 9.6 / 40/100 kbps
26 GPIO, 15 are tolerant of 5V, 5 are able to wake the device from deep sleep
4 ADC
4 PWM
3 UART
3 SPI
16 interruptions
1 I2C
2 16-bit timers, 1 32-bit timer (GPT)
1-Wire (software) (overlaps with special hardware drivers)
2 service LEDs
1 service button
1 user test LED
CSEN interface for capacitive touch buttons
LDMA controller for fast data transfers
32-bit 39Mhz Cortex M4F CPU
Channel types:

Binary switch
Multilevel switch
Color switch
Binary sensor
Multi-level sensor
Measurer
Z-Wave Supported Features:

Compatible with Z-Wave Plus V2
Z-Wave Smart Start technology support
Long-range Z-Wave support
All Z-Wave frequencies
AES 128-bit security S2 and S0 modes
OTA or USB firmware updates
Multichannel (32 channels)
32 association groups
Control switches, dimmers, door locks and scenes
Works with gateways and / or directly with other Z-Wave devices