FIBARO Bypass for the Dimmer 2

The FIBARO Bypass 2 is a module designed to work with the Fibero Dimmer 2 (FGD-212), and be used with LED bulbs or low consumption fluorescent lamps. It allows to regulate the Fibaro Dimmer2 micromodule, bulbs of less than 50W of power. Fibaro Bypass 2 optimizes and avoids flashing LEDs and energy saving light bulbs.

By installing it in 2-wire mode, bypass 2 reduces the power of the minimum load required by the unit for proper operation. This Bypass (FGB-002) provides capacity for the control of small loads to Fibaro's Dimmer 2.

FUNCTIONS:

• Bypass to vary or regulate the brightness of low consumption lamps.
• Avoid the phenomenon of blinking or that the LED bulbs are a little lit after the shutdown
• Use only with the Fibaro Dimmer 2 -> FGD-212 regulator micromodule
• It is installed in parallel to the bulb inside the coupling of the bulb

TECHNICAL CHARACTERISTICS :

• Power supply: 230V +/- 10% 50Hz
• Consumption: <1.2W
• Dimensions: 31 x 21.6 x 13 mm
• Operating temperature: 0-35 ° C
• Certificates:
  • RoHS 2011/65 / EU
  • LVD 2006/95 / EC
  • EMC 2004/108 / EC