Zooz Z-Wave GPIO Module - Z-Wave 800 Series

Key Features of This Product:

• Wide Range , Speed ​​and Security
• Advanced  Z-Wave Command Class Library
• S2  and  SmartStart security , allows users to create a secure network using UL-level encrypted communications
• New 800 series Z-Wave chip . The latest generation of the chip increases the range and signal performance
• The GPIO 800 Series Z-Wave Module  is an advanced technological device designed for experienced users in the field of smart home automation.

INSTALLATION

NOTE: Bluetooth must be disabled when using this module and installed on pins 1-10 (including the 5V pins). This should be taken into account when planning the hardware installation.

Connect the 800 Series Z-Wave GPIO Module to your Raspberry Pi or Home Assistant Yellow by following the hardware instructions. Use it with your chosen home automation software, including Home Assistant with JS Z-Wave integration. Follow the software vendor's instructions, as configuration may vary depending on the interface and operating system. Please note that the ZAC93 module is intended for advanced users only and requires at least basic knowledge of programming and electronics to provide the best experience.

Home automation software is required to control and configure the Z-Wave network. Compatibility of Z-Wave products will depend on the software chosen, so we recommend installing an open and proven smart home system with the Z-Wave 800 Series GPIO module

TECHNICAL DATA

• Z-Wave Frequency: 868.42 MHz (EU, UK): no Long Range Z-Wave in Europe
• Power: 3.3VDC
• SDK: 7.18
• Operating temperature: -10 to 40° C
• Installation and use: indoor only
• Dimensions: 28mm x 28mm